INAV Target MATEKF722SE for F722-SE & F722-WING S5 doesn’t work for Hex/Octo motor due to normal DMA confliction if RPM filter is enabledĬustomized BetaFlight 4.2.x for new barometer DPS310.you might use this firmware to get Softserial2_TX on S5 pad, Softserial2_RX on S6 pad. if you need the softserial to be full-duplex (TX = ST1 pad, RX = LED pad), at the cost of losing the LED output.softserial_tx1 will be available on the LED pad. if you want to have analog RSSI input on ST1 pad.softserial_tx1 on ST1 pad, softserial_tx2 on LED pad.if you want to use two softserials (TX only) at the same time.Set OSD video format to “AUTO”, Do not have it set to PAL or NTSC, otherwise F411 could hang after rebooting.
Softserial_TX1 is on TX4 pad & Softserial_TX2 is on TX2 pad if CPU based serial port is enabled since 2.0.1.Betaflight legacy target is not released any more in pull-down list of configurator, it has been superseded by the Unified Target since 4.1.2.Pls use INAV2.6 or higher version and new configurator.īetaFlight legacy Target “MATEKF405” for F405-CTR/F405-STD/F405-mini/F405-AIO/F405-OSD INAV2.5.1 downloaded from configurator don’t support new barometer DPS310.with ArduPilot firmware, you might set the onboard DPS310 as external barometer, GND_EXT_BUS ->0, GND_PROBE_EXT ->64.
then connect FC USB to the PC to see if COM port can be detected.įlashing BF/INAV/ArduPilot firmware with STM32CubeProgrammer
reinstall STM VCP drivers without FC connected.
Select STM32 BOOTLOADER in the device list (if instead you see STM32 Virtual Com Port you are not in DFU mode – don’t replace the driver!).Connect the FC USB to the PC While holding the boot button in. (DO NOT power on FC via external 5V or Vbat).Don’t try to use a diff or dump from other version. Always reset to default with defaults in CLI after each reflashing, “full chip erase” can not erase old data completely!.
use configurator 3.0 for fw 3.0.x, use configurator 4.1 for fw 4.1.x